© 2012 Teleflex Marine, Inc. Optimus 360 Users Manual, Rev. A
62
11.0 Maintenance (continued)
After the first 200 hours or 12 months thereafter (whichever
comes first).
1.
All points noted above.
2. Remove support rod from engine steering/tilt tube. Clean engine
steering/tilt tube and re-grease using a good quality marine
grease.
3.
Grease support rod liberally.
4. Grease all contact points shown in the figure below. DO NOT
remover the tiller bolt to re-grease.
5.
Remove the steering wheel and re-grease the wheel shaft using a
good quality marine grease.
6.
Inspect hydraulic oil for cleanliness; flush if required.
7. Check that the service valve is free to move and in the closed
position.
Any work being performed with the steering system MUST be
completed by a qualified mechanic with the working knowledge of
the system.
GREASE SUPPORTROD,
TILTTUBE&SUPPORT
BRACKET HOLE
GREASE SUPPORT ROD,
TILTTUBE&SUPPORT
BRACKET HOLE
Comments to this Manuals