Seastar Solutions Optimus 360 User Manual download pdf (Page 50)

8.4 Installation Checks

1. Interference Checks - Conﬁrm that there is no interference

between the steering cylinder(s), splashwell or outboard engine

or any combination of these parts by performing the steps below.

At the same time for each step also check that the hoses,

harnesses and cables are moving freely with no rubbing or

binding (see ﬁgures below and on right page).

a) With the engines fully tilted DOWN, turn the steering wheel from

hard over to hard over and conﬁrm that no interference occurs.

b) With the engines fully tilted UP, turn the steering wheel from

hard over to hard over and conﬁrm that no interference occurs.

c) Trim the port engine fully DOWN and the starboard engine fully

UP. Turn the steering wheel from hard over to hard over and

conﬁrm that no interference occurs.

d) Trim the starboard engine fully DOWN and the port engine fully

UP. Turn the steering wheel from hard over to hard over and

conﬁrm that no interference occurs.

To verify correct installation of the Optimus 360 SmartCylinder,

perform the following installation checks when the boat is

delivered and after each boat servicing.

Failure to perform these checks may result in damage to the

SmartCylinder sensor and affect the safe operation of the boat’s

steering.

If any issues are found during the installation checks, immediately

return the boat to the service dealer for those issues to be

remedied.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 75 76

No comments

Seastar Solutions Optimus 360 User Manual Page 50