Seastar Solutions Optimus 360 User Manual download pdf (Page 7)

1.0 SAFETY INFORMATION

The safety information provided below is intended to inform you of

the dangers that may be present before, during and after use. It is

critical that you read and understand ALL the points noted.

The safe operation of the vessel control system is dependant

upon proper installation and maintenance, common sense, safe

judgement and the knowledge/expertise of the operator. Every

installer/user of the vessel control system should know the following

requirements before installing/using the vessel control system.

If you have any questions regarding any of these warnings, contact

Teleﬂex Marine.

To reduce risk of severe injury or death:

Perform a system inspection as outlined below. Refer to Section 7.3

for further details.

Check steering ﬂuid level in all steering pumps.

2. Verify immediate steering response when turning steering

wheel(s).

Inspect all steering hoses, ﬁttings and mechanical and electrical

cables for wear, kinks, or leaks.

Check for binding, loose, worn or leaking steering or shift/throttle

control components.

Verify proper shift and throttle response for all control handles.

6. Verify that no alarms or warnings are shown on the CANtrak

display.

Do not operate boat if any component is not in proper working

condition.

Prior to every use

The Optimus 360 System MUST ONLY be installed by an authorized

Teleﬂex Marine dealer.

Always wear a Coast Guard Approved personal ﬂotation device

(PFD) and use an engine shut-off cord (lanyard).

Read and understand this User’s manuals and the Quick

Reference Card provided with your vessel control components.

Optimus 360 components are highly engineered and safety

tested to ensure system integrity. DO NOT substitute any

component with non-Optimus 360 components, as this may

compromise system performance/reliability.

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

No comments

Seastar Solutions Optimus 360 User Manual Page 7