Seastar Solutions Optimus 360 User Manual download pdf (Page 67)

11.0 MAINTENANCE

Prior to every use (see Section 8.3 for further details):

1. Check steering ﬂuid level in all steering pumps.

Verify immediate steering response when turning steering

wheel(s).

Inspect all steering hoses, ﬁttings and mechanical and electrical

cables for wear, kinks, or leaks.

Check for binding, loose, worn or leaking steering or shift/throttle

control components.

Verify proper shift and throttle response to all control handles.

6. Verify that no faults or warnings are shown on the CANtrak

display or on the Shift and Throttle Control Head.

Following the routine maintenance schedules as outlined below,

in the time frame noted will ensure years of service from your

Optimus 360 Joystick control system, as well as keep you and your

passengers safe from the dangers that are present on and off the

water.

1. Owner(s) (End Users)

WARNING

Do not operate boat if any component is not in proper working

condition.

After every use:

1. Rinse the SmartCylinders with clean water and replace CANtrak

sun cover.

Do NOT rinse the PCM, pumps, or the actuators.

2. Qualiﬁed Marine

Mechanic

After the ﬁrst 20 hours, then every 100 hours or 6 months

thereafter (whichever comes ﬁrst).

All points noted above.

2. Check tightness of ALL fasteners/ﬁttings throughout the vessel

control system. Tighten to correct torque speciﬁcations as

required.

3. Check for mechanical play or slop throughout vessel control

system, correct as required.

Check for signs of corrosion. If corrosion is present contact your

dealer or Teleﬂex Marine.

Check all electrical harnesses and mechanical cables for

chafﬁng and wear.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

No comments

Seastar Solutions Optimus 360 User Manual Page 67