Seastar Solutions Optimus 360 User Manual download pdf (Page 64)

10.2.4 System Fault Handling – Example

The following is an example of how the system would respond to the

warning fault hazard of a low port engine battery.

The CANtrak display will enter the warning screen mode and pulse

the system warning buzzer. The three warning screen zones will

appear as shown below.

In this case, the CANtrak tells the user to power off any non

essential devices and to seek technical support as fault handling

instructions. It also informs the user that the system has switched

to the starboard battery and reduced the steering speed.

The vessel should be returned to port immediately for repair.

Active Fault

Description Zone

Fault Handling

Instructions Zone

System Status Zone

This area shows the

active faults

Tells the User how

to proceed

Describes what system has

done to react to fault

10.2.5 CANtrak Loss of Display

In the event of a loss of CANtrak display operation proceed as

follows:

On a multiple helm station vessel each station should be

equipped with a CANtrak display. Proceed to navigate from

another helm station and immediately return to port for service.

2. If there are no secondary displays on board, at low speed

carefully verify that the steering system and shift and throttle

operates normally then immediately and cautiously proceed to

port for service.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 75 76

No comments

Seastar Solutions Optimus 360 User Manual Page 64